Do not use the scan feature as we are going to use Auto Bouquets Maker instead Exit all screens and go to plugins, green button to download, go to system plugins and find autobouquetsmaker, press OK to download, exit screens and reboot receiver. then press OK a couple of times to finish the wizard. To set tuner A press OK (dont change any settings) Do the same on any other tuners or disable them if not needed. Now the start wizard will guide you through, press OK, use the wizard. Setting up your new image On first load choose HDMI, 1080i, 50Hz Language English, Click yes to delete other languages. Let the receiver boot up fully then power back down and take out the USB stick out and replace with a new one or format that stick and place back into the receiver. (different models of receiver require you to carry out this process slightly different but there is always a message on screen to guide you) Flashing will take about 5 minutes Once your receiver has finished flashing, it will reboot. The display will now change to FLSH, as your new image is being flashed to your box. Press the standby button on your receiver while it says USB. The display will initially show boot, followed by USB if done correctly. Make sure the receiver is turned off (on/off button at rear) and place the USB stick in a USB port of the receiver. On your USB stick you should then just have 1 folder called *receiver name*. You are copying the *receiver name* folder, not the contents of the *receiver name* folder. ** Copy the *receiver name* folder onto the USB stick. This folder needs transferring to a freshly formatted USB stick smaller than 32 GB and fat 32 Flashing the new firmware ** If reflashing over a prevoius image Make sure you have backed up any prepaid lines before continuing.

Inside this zip file will be a folder called *receiver name*. Click on *your receiver* Click on OpenATV Download the zip file of the latest nightly build. Firmware Search the internet for Open ATV 6 and find the most recent OpenATV firmware for your receiver. Setting up your receiver Set up your receiver and plug in your cable TV feed into RF in (you may need a F-plug connector) Loop through to additional tuners if you have a multi tuner receiver.

Whilst setting up, if it’s mentioned to reboot/restart your receiver then do this by using your remote, press and hold the power button down for 3 seconds when you see a list choose option restart.

All the information you require should be in the guide if there's anything your unsure about, post in the thread below and someone will kindly answer.

Openatv 6.2 softcam feed ipk download